Due to the quickly exchangeable inserts for the nozzle and ejector side, different standard test specimens such as tension tests, impact bending tests, sample plates or flow spirals can be produced one after the other without time delays. The inserts are connected directly to the temperature control system via quick-release couplings without water loss. The test mold is immediately ready for the next injection molding shot.
The master tool is for the mounting of the interchangeable inserts. The tool inserts are replaced without timedelay. No screws or temperature control hoses have to be disconnected. The change of the inserts lasts only seconds.
For most test specimens, the nozzle-side interchangeable insert is a mirror plate. The nozzle-side can also be supplied with pressure sensors or temperature sensors on request.
The mold cavity is housed in the interchangeable insert on the closing side. The ejectors are connected directly to the ejector mechanism of the injection molding machine. The test specimens can thus be produced free-falling or removed by robots.
The tool offers a standard tool temperature of 20...180°C and M12 mounting holes. The dimensions as well as other options can be customized if required.
Other changes can be customized.
We have a wide range of inserts for your standard specimens, such as tension rods, bending rods, plates or flow spirals, these can be found in our brochure. If required, we can also construct special designs.